Effect of carbon nanomaterials additives on the properties of epoxy composites
Abstract
The possibility of using CNM synthesized by pyrolysis, as a modifier when creating new PCM-based epoxy resin and carbon reinforcing filler. It is established that the introduction of CNM as fillers leads to an increase in bending fatigue stress at 28% compression at 38% and at break of 14%. Determined that the fire resistance of composites increases with the number of input CNM.
References
1. Мансуров З. А. Образование сажи, полициклических ароматических углеводородов, фуллеренов и углеродных нанотрубок при горении углеводорода // Инженерно-физический журнал, М., 2011. – Т.84, № 1. - С.111-145.
2. Грачев В.П., Акатентов Р.В., Алексашин В.Н., Богатов Б.А., Кондрашов С.В., Раков Э.Г., Аношкин И.В. // Влияние малых добавок функционализированных многослойных углеродных нанотрубок на кинетику отверждения и свойства эпоксидных композитов // Сборник тезисов докладов участников Второго Международного форума по нанотехнологиям, 2009, С. 301-303.
3. Breuer O., Sundararaj U. Big returns from small fibers: a review of polymer/carbon nanotubes composites // Polym. Compos. - 2004. - Vol. 25, № 6. - Р. 630-645.
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License (CC BY-NC-ND 4.0) that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.